Scribd
Upload
196 views1 page

Table Pw-39 (Cont'D) Mandatory Requirements For Postweld Heat Treatment of Pressure Parts and Attachments

The document provides requirements for postweld heat treatment of pressure parts and attachments. It specifies that for Group 07 materials, postweld heat treatment is not required or prohibited up to a weld thickness of 5 inches. It also provides postweld heat treatment temperature and holding time requirements for alloy S31803. Finally, it notes that for material P-No. 10r, postweld heat treatment shall be performed as described in section PW-39.3, with a maximum cooling rate of 100°F/hr above 1,200°F, and then rapid cooling to prevent embrittlement.

Uploaded by

Panchal Shailesh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
196 views1 page

Table Pw-39 (Cont'D) Mandatory Requirements For Postweld Heat Treatment of Pressure Parts and Attachments

The document provides requirements for postweld heat treatment of pressure parts and attachments. It specifies that for Group 07 materials, postweld heat treatment is not required or prohibited up to a weld thickness of 5 inches. It also provides postweld heat treatment temperature and holding time requirements for alloy S31803. Finally, it notes that for material P-No. 10r, postweld heat treatment shall be performed as described in section PW-39.3, with a maximum cooling rate of 100°F/hr above 1,200°F, and then rapid cooling to prevent embrittlement.

Uploaded by

Panchal Shailesh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2007 SECTION I

TABLE PW-39 (CONT'D) MANDATORY REQUIREMENTS FOR POSTWELD HEAT TREATMENT OF PRESSURE PARTS AND ATTACHMENTS
Minimum Normal Holding Temperature, OF Material P-No. 10H Group No.1
(OC)

07

Minimum Holding Time at Normal Temperature for Weld Thickness

Up to 2 in. (50 mm)


None

Over 2 in. (50 mm) to 5 in. (125 mm) None

Over

5 in.

(125 mm)
None

None

GENERAL NOTE: For the austenitic-ferratic wrought duplex stainless steels listed below, postweld heat treatment is neither required nor prohibited, but any heat treatment applied shall be performed as listed below and followed by liquid quenching or rapid cooling by other means.

Postweld Heat Treatment, Temperature, OF Alloy S31803 1870-2010


(OC)

(1020-1100)

Minimum Holding Temperature, Material P-No. lor Group No.1


OF (OC)

Minimum Holding Time at Normal Temperature for Weld Thickness (Nominal)

Up to 2 in. (50 mm)


1 hr/in. (2 min/mm), 15 min minimum

Over 2 in. (50 mm) to 5 in. (125 mm) 1 hr/in. (2 min/mm)

Over

5 in. (125 mm)

1,250 (675)

1 hr/in. (2 min/mm)

GENERAL NOTE: Postweld heattreatmentfor P-No.10r (SA-268 TP446 material only) shall be performed as described in PW-39.3, except that the cooling rate shall be a maximum of 100F/hr (60C/hr) above 1,200F (650C) after which the cooling rate shall be sufficiently rapid to prevent embrittlement.

99

You might also like