Scribd
Upload
26 views1 page

Microcontroller Based Anesthesia Injector

The document describes a microcontroller-based anesthesia injector system for hospitals. The system is designed to automatically administer anesthesia to patients during long surgeries in a controlled manner. It consists of a microcontroller, keypad, and syringe infusion pump. The anesthesiologist can set the anesthesia dosage level in milliliters per hour using the keypad. The microcontroller then controls the pump motor to administer the correct dosage on a scheduled interval. An alarm alerts physicians if the anesthesia level drops below the set value.

Uploaded by

Chitransh Ranjan Srivastav
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
26 views1 page

Microcontroller Based Anesthesia Injector

The document describes a microcontroller-based anesthesia injector system for hospitals. The system is designed to automatically administer anesthesia to patients during long surgeries in a controlled manner. It consists of a microcontroller, keypad, and syringe infusion pump. The anesthesiologist can set the anesthesia dosage level in milliliters per hour using the keypad. The microcontroller then controls the pump motor to administer the correct dosage on a scheduled interval. An alarm alerts physicians if the anesthesia level drops below the set value.

Uploaded by

Chitransh Ranjan Srivastav
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

MICROCONTROLLER BASED ANESTHESIA INJECTOR

In the hospitals when any major operation is performed, the patient must be in anesthetize condition. If the operation lasts for a long time, say for suppose for 4 or 5 hours, complete dose of anesthesia cannot be administered in a single stroke. It may lead to the patients death. If lower amount of anesthesia is administered, the patient may wakeup at the middle of the operation. To avoid this, the anesthetist administers few milliliters of anesthesia per hour to the patient. If the anesthetist fails to administer the anesthesia to the patient at the particular time interval, other allied problems may arise. To overcome such hazardous problems the design of an automatic operation of an anesthesia machine based on a micro-controller is effective. In this system a keypad is provided along with the microcontroller and syringe infusion pump. The anesthetist can set the level of anesthesia in terms of milliliters per hour to administer anesthesia to the patient with the help of keypad. After receiving the signal from the keypad, the microcontroller controls the signal to the desire level and fed into the stepper motor to drive the infusion pump in proper manner. The anesthesia is administered to the patient according to the stepper motor rotation (the syringe will move forward or backward direction). This particular paper will be very much useful to physicians to see the current position of anesthesia of the patients. If the level of anesthesia is decreased to lower level (set value), the alarm will be initiated to alert the physician to refill the anesthesia in the Syringe Pump to continue the process.
.

You might also like