Scribd
Upload
120 views2 pages

Tutorial Problems On Mtodule-3

The document contains three power flow analysis problems: 1. For a 5 bus system, calculate the bus admittance (Y) matrix given the line impedance and charging data. 2. For a 3 bus system with two generators, calculate the generator outputs at buses 1 and 2, as well as the voltage magnitude and angle at bus 3. 3. For a 3 bus system with one slack bus, one PV bus, and one PQ bus, calculate the power flow solution given the generator output at bus 2 and the load at bus 3.

Uploaded by

stackzzz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
120 views2 pages

Tutorial Problems On Mtodule-3

The document contains three power flow analysis problems: 1. For a 5 bus system, calculate the bus admittance (Y) matrix given the line impedance and charging data. 2. For a 3 bus system with two generators, calculate the generator outputs at buses 1 and 2, as well as the voltage magnitude and angle at bus 3. 3. For a 3 bus system with one slack bus, one PV bus, and one PQ bus, calculate the power flow solution given the generator output at bus 2 and the load at bus 3.

Uploaded by

stackzzz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Tutorial Problems on Module-3 Power Flow Analysis Problem-1 For the system given below, find the Y-Bus

matrix. All line data are in per unit.


G 1 3 G 4

2 G

Table-1: Line Data (all data are in pu) Line Impedance, Line i-j Zij Charging yij 1-2 0.02 + j 0.06 j0.03 1-3 0.08 + j0.24 j0.025 2-3 0.06 + j0.18 j0.02 2-5 0.04 + j0.12 j0.015 3-4 0.01 + j0.03 j0.10 4-5 0.08 + j0.24 j0.025

Problem-2 For the system in the figure below, find the generator outputs at bus-1 and bus-2, in per unit. Also determine the bus-3 voltage magnitude |V3| the corresponding angle 3. Given that both the transmission lines have equal impedances of 0.1 per unit. Other parameters are given alongside the figure.

10

1.050

j 0.1

j 0.1

V3d3

0.9+j 0.4

Problem-3 Consider the system shown in the figure below. Bus #1 and Bus #2 have generators connected to them while Bus #3 has a load connected to it, as shown. We shall consider Bus #1 to be the slack bus. Also we know that Bus #2 is a PV bus and Bus #3 is a PQ bus. It is also given that the generation from Gen-2 is 0.6661 p.u.

G V1=1.0 0 o 1

G PG2 = 0.6661 p.u. |V2 |=1.05 2

3 2.8653+j1.2244 p.u.

All transmission lines admittances are equal, and line charging susceptances are equal, as follows: y12 = -j10; b12 = j0.02; y13 = -j10; b13 = j0.02; y23 = -j10; b23 = j0.02; Find the power flow solution of the given system.

You might also like