Scribd
Upload
34 views

Rotary Encoder

318-ENC130175F-12PS C A (CW) off on off (B Term BC) on (CCW) on (A Term AC) mechanical specifications: Rating: 1mA / 10VDC Operating Temp: -10degC to 70degC Dielectric Strength: 50VAC for 1 min. Soldering Specifications: to be performed in 5 seconds within 260+-5degC the terminals for 10 sec. In Manual Soldering: To

Uploaded by

Mahmoud El-Mahdy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Rotary Encoder

318-ENC130175F-12PS C A (CW) off on off (B Term BC) on (CCW) on (A Term AC) mechanical specifications: Rating: 1mA / 10VDC Operating Temp: -10degC to 70degC Dielectric Strength: 50VAC for 1 min. Soldering Specifications: to be performed in 5 seconds within 260+-5degC the terminals for 10 sec. In Manual Soldering: To

Uploaded by

Mahmoud El-Mahdy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Date: 07-16-08

Ref.#: TW-700198

Rotary Encoder
318-ENC130175F-12PS

.50.40
(.02.016)

Dimensions: mm (in.)

6.10
(.236.004)

4.5.10
(.177.004)
C0.7

13.2
(.52)

5
(.20)
11.5
(.45)
17.5
(.689)

5
(.20)

6.8.20
(.267.008)

5
(.20)

14 12.5 8.4
(.55) (.49) (.33)

.90
6.50 (.035)
(.236.02)

3.5.50
(.137.02)
2
(.079)
14.5
(.57)

7.5
(.295)
2-2.10
(.078.004)
2-2.1.10
(.083.004)
5-1.10 hole
(.04.004)
B

13.2
(.52)

C
A

.90.10
(.035.004)

10.2
(.40)

3.5.50
(.137.02)

7
(.275)

5
(.20)

(CW)
off
on
off
(B Term B~C)
on
(CCW)
(A Term A~C)

off
on
off
(B Term B~C)
on
(A Term A~C)

7.5
(.295)

Electrical Specifications:
Mechanical Specifications:
Rating: 1mA/10VDC
Operating Temp: -10C to 70C
Insulation Resistance: 50VDC 10M Min.
Storage Temp: -40C to 85C
Dielectric Strength: 50VAC for 1 min.
Rotational Torque: 50gf.cm max.
Resolution: 12 pulses/360 for each phase
No. and Pos. of detents: 12 detents
(Step angle 303)
Soldering Specifications:
Terminal Strength: A static load for
300gf.cm shall be applied to the tip of Soldering: To be performed in
5 seconds within 2605C
the terminals for 10 sec. in
Manual Soldering: To be performed in
any direction
3 seconds within 3505C
Shaft push-pull strength: 5.1kgf
Preheating: The entire flow duration
Rotational life: 30,000 cycles
should not exceed 2 min., and soldering
Note:
surface temperature (undersurface of
RoHS Compliant
PCB) shall be settled within 100C

Available from Mouser Electronics

www.mouser.com

Push-on Switch
Specifications:
Type: Single Pole
Single Throw (Push on)
Rating: 10mA/5VDC
Switch Travel (mm): 0.50.4
Operating Force: 200~460gf
Operating Life: 20,000 times

(800) 346-6873

Specications are subject to change without notice. No liability or warranty implied by this information. Environmental compliance based on producer documentation.

You might also like