Scribd
Upload
63 views2 pages

Loss Windage and Friction Power) (P Develope Power: Shaft Mechanical

This document outlines the steps and formulas used to perform various tests on an induction motor and calculate its electrical parameters. These tests include: no-load test to determine synchronous reactance; blocked rotor test to determine stator and rotor resistances and leakage reactances; and locked rotor test to determine rotor resistance and leakage reactance. The results of these tests are then used to calculate additional parameters like magnetizing reactance, torque, and rotor resistance at start.

Uploaded by

kumararguru
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
63 views2 pages

Loss Windage and Friction Power) (P Develope Power: Shaft Mechanical

This document outlines the steps and formulas used to perform various tests on an induction motor and calculate its electrical parameters. These tests include: no-load test to determine synchronous reactance; blocked rotor test to determine stator and rotor resistances and leakage reactances; and locked rotor test to determine rotor resistance and leakage reactance. The results of these tests are then used to calculate additional parameters like magnetizing reactance, torque, and rotor resistance at start.

Uploaded by

kumararguru
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

full load shaft power HP * 746

mechanical power develope (p m ) shaft power friction and windage loss


synchronous speed (n s ) f / p
slip ns n ns

air gap (p ag ) pm /(1 s )


rotor copper loss (p cu2 ) spag

No load test

z NL NL 3I NL

RNL PNL / 3I NL
X NL
2

Z NL R 2 C

From the dc stator resistance measurement:

R1 RNL 2
BLOCKED LOAD TEST

Z IN V 3I
' R1 R2 P 3I 2

' 2 ' 2 X1 X 2 Z IN ( R1 R2 )

To determine leakage reactances at 60 Hz:


' X L ( F1 F2 )( X 1' X 2 )

To find the magnetizing reactance:

X M X NL X 1
PG PNL 3I 2 R1

S 2F / P
TL PG S
To calculate rotor resistance and leakage reactance
' ' R2 ( R1 R2 ) R1

From the locked-rotor test

V Z 3I

P 3I 2

' X2 X X1

X Z 2 R2
To calculate rotor resistance at start

R fl R R1
' ' 2 R2 S R fl [( X 2 X M ) X M ]

You might also like