Scribd
Upload
1K views7 pages

Guia Easytronic OP-Com

The document provides instructions for adjusting the clutch and gear adaptation on an Easytronic transmission through two processes: touch point adaptation and learning gearbox parameters. Touch point adaptation synchronously changes values to optimize clutch engagement points. Learning gearbox parameters occurs in two phases, first learning gear positions 1-5 while the wheels are free to turn, then synchronizing positions with the engine running.

Uploaded by

Roman Txueko LH
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views7 pages

Guia Easytronic OP-Com

The document provides instructions for adjusting the clutch and gear adaptation on an Easytronic transmission through two processes: touch point adaptation and learning gearbox parameters. Touch point adaptation synchronously changes values to optimize clutch engagement points. Learning gearbox parameters occurs in two phases, first learning gear positions 1-5 while the wheels are free to turn, then synchronizing positions with the engine running.

Uploaded by

Roman Txueko LH
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Adjusting the clutch and gear adaptation Easytronic For normal operation the Easytronic gearbox must periodically

have maintenance work on adjusting the point of setting for the clutch and gear box adaptation. Diagnostics> Vehicle Type> Transmission> MTA Easytronic Next select Programming and the following menu will appear.

Adaptation point setting (Touch Point Adaptation)


1. Engine on and box in neutral position. Select Touch Point Adaptation 2. Follow the instructions that appear on the screen and observe the process of adaptation.

In the process of training the values are synchronously changed from larger to smaller and vice versa After the process has finished it will say settings stored, Programming done! At the beginning of the process, you may receive the following Message: Conditions not correct! You need to exit from the controller and from the program, Stop and restart the car, Re-enter the controller and repeat the process.

Learning Gearbox Parameters

1. For this procedure is you need to jack up the front wheels of the car so that they can rotate freely. 2. Turn the ignition but dont start the engine until prompted. Select neutral with the handbrake on.

Confirm the choice by pressing OK.

The first phase will learn the gear positions 1st to 5th.

After the first part is complete, Push the brake pedal and start the engine, then click OK

Second phase will synchronize the gear positions.

Once the process has completed lower the vehicle to the ground and test drive.

You might also like