Scribd
Upload
173 views1 page

Point at : Loads 48 KN and 40 KN A and 3 Left

A beam is simply supported and carries point loads of 48 kN and 40 kN located 1 m and 3 m from the left support. Compute the slope and deflection under each load. A hollow cast iron strut is 150 mm outer diameter, 100 mm inner diameter, and 5 m long with one end pinned and the other fixed. It is subjected to an axial compressive load. Calculate the safe load using a factor of safety of 5 and Rankine's constants of 550 N/mm and 1/1600. A cylindrical shell is 800 mm diameter, 3 m long, and 10 mm thick. Calculate the change in diameter, length, and volume if subjected to an internal pressure of 2.5 N

Uploaded by

Technical4u
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
173 views1 page

Point at : Loads 48 KN and 40 KN A and 3 Left

A beam is simply supported and carries point loads of 48 kN and 40 kN located 1 m and 3 m from the left support. Compute the slope and deflection under each load. A hollow cast iron strut is 150 mm outer diameter, 100 mm inner diameter, and 5 m long with one end pinned and the other fixed. It is subjected to an axial compressive load. Calculate the safe load using a factor of safety of 5 and Rankine's constants of 550 N/mm and 1/1600. A cylindrical shell is 800 mm diameter, 3 m long, and 10 mm thick. Calculate the change in diameter, length, and volume if subjected to an internal pressure of 2.5 N

Uploaded by

Technical4u
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

(a)

I m and 3 m respectively from the left support. Compute the slope and deflection under eachlsad. Assurne EI = 170O0 kN-m',
point loads of 48 kN and 40 kN at a distance of

A beam of length 6 m is simply supported at the ends and carries two

Or.
(b)

in diameter and I jointed and other end is fixe,!, is subjected to an m long, one end pin axial compressive load. Taking factor of safety as 5 and Rankine's constants 550 N/mm, and 1/1600, calculate the safe load.
A hollow cast iron strut 150 mm outer and 100 mm

(a)

A cylindrical shell 800 mm in diameter, 3 m long is having 10 mm metal thickness. If the shell is subjecred to an internal pressure of 2.5
N,/mm2,

(i) the change in diameter (ii) the change in length and (iii) the change in volume.
Assume the modulus of elasticity and Poisson's ratio of the material of the shell as 200 kN/mm, and 0.25 respectively.

(b)

Or (in N/mm?) afiing at a certain point of the snained The state of sress material ls stror rn in Fig. Q 15(b). Compute (i) The magnitude and nature of principal stresses and

(ii)

The orientatioil sf principal planes.

1g
Fie. Q. 1s(b)

11410

You might also like