Scribd
Upload
49 views2 pages

Serial Port Programmer For 8/18/28/40 Pin Pic Microcontrollers and I2C Eeproms + Icsp Connector and Cable

The PIC-PG2 is a serial port programmer that supports programming 8, 18, 28, and 40 pin PIC microcontrollers and I2C EEPROMs through an RS232 serial port. It comes with an ICSP cable for direct connection to PIC prototype boards and supports programming through the current version of ICPROG software. The dimensions are 50x30mm plus a 30cm ICSP cable and it may not work with all low power serial interfaces or USB to serial cables.

Uploaded by

قرين لطفي
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views2 pages

Serial Port Programmer For 8/18/28/40 Pin Pic Microcontrollers and I2C Eeproms + Icsp Connector and Cable

The PIC-PG2 is a serial port programmer that supports programming 8, 18, 28, and 40 pin PIC microcontrollers and I2C EEPROMs through an RS232 serial port. It comes with an ICSP cable for direct connection to PIC prototype boards and supports programming through the current version of ICPROG software. The dimensions are 50x30mm plus a 30cm ICSP cable and it may not work with all low power serial interfaces or USB to serial cables.

Uploaded by

قرين لطفي
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

PIC-PG2 - SERIAL PORT PROGRAMMER FOR 8/18/28/40 PIN PIC MICROCONTROLLERS AND I2C EEPROMS + ICSP connector and

cable

FEATURES:

PIC-PG2 is programmer based on JDM design which takes all necessary signals and power supply from RS232 serial port. It supports 8, 18, 28 and 40 pin PIC microcontrollers which allow serial programming and I2C EEPROM memories. Programmer comes with ICSP cable for direct connection to PIC-Pxx prototype boards. The supported devices depend on the current version of ICPROG software. Dimensions 50x30 mm (1.95x1.2") + 30 cm (12") ICSP cable

DOCUMENTS:

PIC-PG2.pdf - Users manual

NOTE: The programmer may not work with low power serial interfaces - i.e. laptop or notebook serial ports. USB to serial cables have also not been proven to work.

HARDWARE:

PIC-PG2 schematic PIC ICSP connector

SOFTWARE:
http://olimex.com/dev/pic-pg2.html

You might also like