Workshop Glove Creature
Workshop Glove Creature
Workshop Glove Creature
You will need: two gloves; needle and thread; toy filler; wiggly eyes or buttons; glue.
1. Turn both of
the gloves inside out. Using small running stitches, sew across the base of the middle two fingers. Then, sew across the base of the thumb.
2. Cut off
the middle two fingers and the thumb of each glove. Turn the gloves rightside out. Taking care to stuff the fingers, fill both gloves with toy filler.
of the glove for the body over the cuff of the glove for the head. Slip stitch in place.
4. Stuff
two fingers and a thumb with toy filler. Tuck the cut edges of the fingers and thumb to the inside. Slip stitch the fingers to the sides of the body and the thumb to the back. You may wish to shorten a third finger and use it as a nose. Glue the eyes in place.
Even if you use large gloves, there is only approximately 40cm of hand sewing. You can do that!
All rights reserved. This project sheet is for personal use only. No part may not be copied, reproduced, or distributed nor may the finished project or part of the project be manufactured for purpose of sale without written permission of the copyright holder.