Scribd
Upload
979 views

Stepper Motor Tutorial

Stepper motors can be used in various areas of your microcontroller projects. Unipolar stepper motor has five or six wires and four coils. Bipolar steppers have two independent sets of coils instead of a common center connection.

Uploaded by

api-195761152
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
979 views

Stepper Motor Tutorial

Stepper motors can be used in various areas of your microcontroller projects. Unipolar stepper motor has five or six wires and four coils. Bipolar steppers have two independent sets of coils instead of a common center connection.

Uploaded by

api-195761152
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Stepper Motor Tutorial Introduction

This section of tutorial will explain you everything that you need to know about stepper motors. Stepper motors can be used in various areas of your microcontroller projects such as making robots, robotic arm, and automatic door lock System etc. This tutorial will explain you construction of stepper motors (unipolar and bipolar stepper motors ), basic principle, different controlling types (Half step and Full step), Interfacing Techniques (using L293D or ULN2003) and programming your microcontroller in C and assembly to control stepper motor.

Unipolar stepper motor


The unipolar stepper motor has five or six wires and four coils (actually two coils divided by center connections on each coil). The center connections of the coils are tied together and used as the power connection. They are called unipolar steppers because power always comes in on this one pole.

Bipolar stepper motor


The bipolar stepper motor usually has four wires coming out of it. Unlike unipolar steppers, bipolar steppers have no common center connection. They have two independent sets of coils instead. You can distinguish them from unipolar steppers by measuring the resistance between the wires. You should find two pairs of wires with equal resistance. If you've got the leads of your meter connected to two wires that are not connected (i.e. not attached to the same coil), you should see infinite resistance (or no continuity). As already said, we will talk mostly on "Unipolar stepper motors" which is most common type of stepper motor available in the market.A simple example of 6 lead step motor is given below and in 5 lead step motor wire 5 and 6 are joined together to make 1 wire as common. Step Sequence: Stepper motors can be driven in two different patterns or sequences. Namely, Full Step Sequence Half Step Sequence We will go through theses sequences one by one.

Full Step Sequence


In the full step sequence, two coils are energized at the same time and motor shaft rotates. The order in which coils has to be energized is given in the table below.

Full Mode Sequence Step 0 1 2 3 A 1 0 0 1 B 1 1 0 0 A\ 0 1 1 0 B\ 0 0 1 1

Half Step Sequence


In Half mode step sequence, motor step angle reduces to half the angle in full mode. So the angular resolution is also increased i.e. it becomes double the angular resolution in full mode. Also in half mode sequence the number of steps gets doubled as that of full mode. Half mode is usually preferred over full mode. Table below shows the pattern of energizing the coils.

Half Mode Sequence Step 0 1 2 3 4 5 6 7 A 1 0 0 0 0 0 1 1 B 1 1 1 0 0 0 0 0 A\ 0 0 1 1 1 0 0 0 B\ 0 0 0 0 1 1 1 0

You might also like