0% found this document useful (0 votes)
1K views3 pages

Opcom Manual DPF Regeneration

This document provides information on forced regeneration of diesel particulate filters (DPFs) for various vehicle models, noting that the process increases exhaust gas temperatures over 600°C so it must be done outside on non-flammable ground, and can only be done once to avoid damage. Prerequisites are an idling, warmed up engine.

Uploaded by

Drakooola
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
1K views3 pages

Opcom Manual DPF Regeneration

This document provides information on forced regeneration of diesel particulate filters (DPFs) for various vehicle models, noting that the process increases exhaust gas temperatures over 600°C so it must be done outside on non-flammable ground, and can only be done once to avoid damage. Prerequisites are an idling, warmed up engine.

Uploaded by

Drakooola
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Forced DPF Regeneration

You can start the forced regeneration on the following models:

Astra-H

Z19DT, Z19DTH, Z19DTL, Z17DTR, Z17DTJ

Zafira-B

Z19DT, Z19DTH, Z19DTL, Z17DTR, Z17DTJ

Vectra-C / Signum

Z19DT, Z19DTH, Z19DTL

Corsa-D

Z13DTH, Z17DTR

Antara

2.0L Diesel engine

Warning
The exhaust gas temperature will increase to over 600 C, so you must perform this outside, on a non-flammable ground. The regeneration procedure is completely controlled by the engine control unit.

Prerequisites

Engine is running at idle Engine is fully warmed up To avoid consequential damages, the DPF regeneration must be executed only once!

EDC16 System

Note, after "DPF Regeneration" is finished live data "Diesel Particulate Filter Saturation" will show 70%. When engine controller has performed a dynamic regeneration value will be changed.

DECE01 System

You might also like