Scribd
Upload
83K views1 page

Minimum Edge Distance Table AISC ANSI 360 10 Specifications For Structural Steel Buildings

The document contains two tables that specify minimum edge distance requirements from the center of a standard hole to the edge of a connected part for various bolt diameters. The tables provide minimum edge distances in inches and millimeters. A note explains that lesser edge distances are permitted if other provisions are satisfied but must be approved by the engineer.

Uploaded by

Dean Anders
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
83K views1 page

Minimum Edge Distance Table AISC ANSI 360 10 Specifications For Structural Steel Buildings

The document contains two tables that specify minimum edge distance requirements from the center of a standard hole to the edge of a connected part for various bolt diameters. The tables provide minimum edge distances in inches and millimeters. A note explains that lesser edge distances are permitted if other provisions are satisfied but must be approved by the engineer.

Uploaded by

Dean Anders
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Sect. J3.

BOLTS AND THREADED PARTS

16.1123

TABLE J3.4 Minimum Edge Distance[a] from Center of Standard Hole[b] to Edge of Connected Part, in.
Bolt Diameter, in.
1/2 5/8 3/4 7/8

Minimum Edge Distance


3/4 7/8

1 11/8 11/4 11/2 15/8 11/4 d

1 11/8 11/4 Over 11/4


[a]

If necessary, lesser edge distances are permitted provided the appropriate provisions from Sections J3.10 and J4 are satisfied, but edge distances less than one bolt diameter are not permitted without approval from the engineer of record. [b] For oversized or slotted holes, see Table J3.5.

TABLE J3.4M Minimum Edge Distance[a] from Center of Standard Hole[b] to Edge of Connected Part, mm
Bolt Diameter, mm 16 20 22 24 27 30 36 Over 36
[a]

Minimum Edge Distance 22 26 28 30 34 38 46 1.25d

If necessary, lesser edge distances are permitted provided the appropriate provisions from Sections J3.10 and J4 are satisfied, but edge distances less than one bolt diameter are not permitted without approval from the engineer of record. [b] For oversized or slotted holes, see Table J3.5M.

Specification for Structural Steel Buildings, June 22, 2010

AMERICAN INSTITUTE OF STEEL CONSTRUCTION

You might also like