0% found this document useful (0 votes)
589 views1 page

Lab-00-01 - Configure Cisco 3600 Router To Use As A Switch in GNS3

This document provides steps to configure a Cisco 3600 router to function as an Ethernet switch in GNS3: 1) Add an Ethernet switch symbol in GNS3's symbol manager. 2) Drag the switch node to the work area and rename it to "SW1". 3) Configure the switch node to use the Cisco 3600 chassis with an NM-16ESW module, adding 15 Fast Ethernet interfaces. 4) Start the switch, apply an idle PC value, and configure IP addresses and a default gateway to allow remote access to the switch.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
589 views1 page

Lab-00-01 - Configure Cisco 3600 Router To Use As A Switch in GNS3

This document provides steps to configure a Cisco 3600 router to function as an Ethernet switch in GNS3: 1) Add an Ethernet switch symbol in GNS3's symbol manager. 2) Drag the switch node to the work area and rename it to "SW1". 3) Configure the switch node to use the Cisco 3600 chassis with an NM-16ESW module, adding 15 Fast Ethernet interfaces. 4) Start the switch, apply an idle PC value, and configure IP addresses and a default gateway to allow remote access to the switch.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Lab-00-01 - Configure Cisco 3600 Router to Use as a Switch in GNS3

http://www.4shared.com/rar/LvteY1fY/00-Prepare_Virtual_Network_Env.html

1. Open GNS3. 2. Select EditSymbol Manager. Add ethernet_switch from the available list. 3. In Customized node setting enter and select the following values. Click Apply and then Ok.

4. A new node Cisco Switch is added to the Node types window. Select this and drag it to the work area. Right Click and change Hostname to SW1. 5. Again Right Click and Select Configure, under Routers c3600 select SW1. On Slot tabs, select NM16ESW module in slot 0 to add 15 Fast Ethernet interfaces. Click Apply and Ok.

6. Start the switch. After 5-6 minutes right click and select the Idle PC. Apply the Idle PC value. 7. Double Click switch to open Console and configure the IP address for VLAN and default gateway for switch. This IP address will be used to telnet or SSH a switch.

www.asghars.blogspot.com

You might also like