0% found this document useful (0 votes)
550 views1 page

Gantt Chart

The document outlines a project plan consisting of 7 phases (A through G) to develop a load flow solver for three-phase unbalanced distribution systems. It includes a Gantt chart showing the timeline for each task and phase from November to March, with a halfway presentation in January and final presentation in March. The document describes the objectives and tasks for each phase of the project.

Uploaded by

Limuel Estorque
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
550 views1 page

Gantt Chart

The document outlines a project plan consisting of 7 phases (A through G) to develop a load flow solver for three-phase unbalanced distribution systems. It includes a Gantt chart showing the timeline for each task and phase from November to March, with a halfway presentation in January and final presentation in March. The document describes the objectives and tasks for each phase of the project.

Uploaded by

Limuel Estorque
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Week A a.1 a.2 B C c.1 c.2 c.3 D E F f.1 f.2 f.

3 G

November 1 2 3 4

December 1 2 3 4

January 2 3

February 1 2 3 4

March 2 3

Halfway Presentation

Final Presentation

6.1 Gantt Chart Phase A: Develop load flow solver for three-phase unbalanced distribution systems a.1: Identifying the components of the distribution network and their models. a.2: Development of a dynamic load flow program with Graphical User Interface in Matlab Phase B: Integrate the load flow solver in evaluating the system configurations Phase C: Develop the searching procedure or the optimization algorithm c.1: Studying Genetic Algorithm (a) Initialization (b) Evolution (c) Termination c.2; Identification of the features of the Proposed Optimization Algorithm c.3: Development of a working code/program for Genetic Algorithm Phase D: Integrate C with the routines devoped in phase A & B Phase E: Working prototype with GUI in Matlab Phase F: Checking and Testing for different scenarios. Getting the results f.1: Simulation of single and multiple faults f.2: Cases for Partial Restoration: Proposed Load Curtailment Scheme f.3: Comparison of results with other studies. Phase G: Project Documentation

Phase

You might also like