Scribd
Upload
75 views

Down Draft Ezplan

The document provides plans and instructions for building a downdraft table. It includes a materials list and labeled diagrams of the parts. It details how to cut and assemble the main box pieces and attach additional elements like cleats, ramps, and a dust collection port.

Uploaded by

tasalad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
75 views

Down Draft Ezplan

The document provides plans and instructions for building a downdraft table. It includes a materials list and labeled diagrams of the parts. It details how to cut and assemble the main box pieces and attach additional elements like cleats, ramps, and a dust collection port.

Uploaded by

tasalad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Downdraft Table Plan

E
D

MATERIALS LIST

Quantity
B

A - Side 63/4" x 171/2" x 1/2" 2 1 B - Front 63/4" x 27" x 1/2" C - Back 63/4" x 27" x 1/2" 1 1 D - Bottom 17" x 271/2" x 1/2" E - Side Cleat 3/4" x 151/2" x 1/2" 2 F - Front and Back Cleat 3/4" x 27" x 1/2" 2 G - Ramps 12" x 161/2" x 1/2" 2 2 sets Downdraft Table Panels (25077) Dust Right Combo Port (28666) or Blast Gate (88486) 1

20 edge 45 edge
Fig. 1 - Cross-section

20 edge

Instructions:
1. 2. 3. 4. 5. 6. 7. 8. 9.

The box pictured above is made of raw MDF to save on cost, but feel free to use whatever material ts your taste. Building the box is fairly simple. It uses mostly butt joints fastened with glue and either screws or nails. Cut each lettered piece to size. Cut a 14" deep x 12" high rabbet on the bottom edge of parts A, B & C. Use a jigsaw to cut a 4" diameter hole in part C. The hole should be 131/2" (on center) from the side edge and 4" (on center) from the top edge. Use glue and either screws or nails to assemble and fasten the main box (parts A, B, & C). Attach the boxs bottom (part D). Attach all four cleats (parts E & F) 7/8" down from the top edge of the box using glue and nails. The downdraft panels will rest here. Cut the long edges of the ramps (G) to 45 and 20. Fig. 1. Attach the ramps with the 20 edge directly under the side cleats and the 45 edge towards the center of the box bottom. Fig. 1. Attach the combo port or blast gate.
Rev. 02/09 2008 Rockler Woodworking and Hardware

10. Use your desired nish to complete the project.

25077 Down Draft Ezplan.indd 1

3/27/09 3:17:25 PM

You might also like