Scribd
Upload
52 views7 pages

Usbasp Download Manual: 1. Hardware Introduction

The USBasp download manual provides instructions for using a USBasp programmer. It includes a hardware introduction describing the included USBasp programmer and cable. It warns to disconnect any power sources from the controller board before connecting the USBasp. The document also provides steps for installing the USBasp driver on a computer and recommends software for using the USBasp, including installing Java and using the KKmulticopter Flash Tool.

Uploaded by

Ruddy Alaca
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
52 views7 pages

Usbasp Download Manual: 1. Hardware Introduction

The USBasp download manual provides instructions for using a USBasp programmer. It includes a hardware introduction describing the included USBasp programmer and cable. It warns to disconnect any power sources from the controller board before connecting the USBasp. The document also provides steps for installing the USBasp driver on a computer and recommends software for using the USBasp, including installing Java and using the KKmulticopter Flash Tool.

Uploaded by

Ruddy Alaca
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

USBasp Download manual

1. Hardware introduction
Package including: USBasp Programmer x 1 10-10-6PIN cable x 1

Pin1: MOSI Pin25.0V to target boardJ1 Jumper connected) Pin4: 6 / 8 / 10GND Pin5Reset Pin7SCK Pin9: MISO Power Jumper J1: Pin2 provides 5V to target board. If the target board is powered remove the jumper. This USBasp has 500mA fuse if using Jumper to provide 5V to target board.

WARNING: Disconnect your controllers power source before plugging the USBasp in to the board. If you need to connect to the board in a powered state remove jumper J1.

2. Driver Install
A) Download the latest driver from http://www.fischl.de/usbasp/ Connect the USBasp to computer USB port. Computer will discover new device.

B) Device driver software was not successfully installed.

C) In Device Manager, Choose Update Driver Software of USBasp.

D) Choose Browse my coputer for driver software.

E) Select the usbasp/driver where the driver file you located.

F) Choose Install this driver software anyway.

G) Wait for installing.

H) Install completed.

I) In Device Manager, libUSB-Win32 Device updated.

3. Software
Driver http://www.fischl.de/usbasp/

We recommend KKmulticopter Flash Tool V0.41. Ensure you have the device driver for USBasp installed before using KKmulticopter Flash Tool V0.41 http://lazyzero.de/en/modellbau/kkmulticopterflashtool#drivers

Ensure you have the latest version of Java installed.

http://java.com/en/download/ie_manual.jsp?locale=en

Correct Connection of the USBasp.

You might also like