Scribd
Upload
212 views2 pages

77.arm Microcontroller Based Involuntary Railway Gate Control System.

This document describes an ARM microcontroller-based involuntary railway gate control system. The system uses IR sensors to detect when a train enters and exits a section, and a microcontroller then controls a stepper motor via a ULN driver to automatically open and close the railway gate. When the gate is closed, a red signal is shown, and when open, a green signal is shown. The hardware includes an ARM7 controller, buzzer, IR sensors, ULN2003 chip, stepper motor, and power supply. The system is programmed using Keil software, embedded C, and Flash Magic.

Uploaded by

Nivas Scs
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
212 views2 pages

77.arm Microcontroller Based Involuntary Railway Gate Control System.

This document describes an ARM microcontroller-based involuntary railway gate control system. The system uses IR sensors to detect when a train enters and exits a section, and a microcontroller then controls a stepper motor via a ULN driver to automatically open and close the railway gate. When the gate is closed, a red signal is shown, and when open, a green signal is shown. The hardware includes an ARM7 controller, buzzer, IR sensors, ULN2003 chip, stepper motor, and power supply. The system is programmed using Keil software, embedded C, and Flash Magic.

Uploaded by

Nivas Scs
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

ARM MICROCONTROLLER BASED INVOLUNTARY RAILWAY GATE CONTROL SYSTEM

ABSTRACT The railway gate is to be controlled so that the road traffic is to be predicted .The railway gate is to be closed when a train is passing by the way. The opening and closing of the gate is to be done using DC motors and this DC motor is controlled by micro controller. The signaling of the train is also controlled depending upon the gate position. Only when gate is closed the red signal is otherwise green signal. So in this project the railway signaling includes the gate control is done using microcontroller. The automatic opening and closing of the gate and also the signaling which depending on the gate position that will be controlled by the microcontroller. This project is based on automatic railway gate opening and closing using IR sensors and whit buzzer Indication while opening or closing of the gate. This project consists of ARM7 controller interfaced with two IR SENSOR sections .when train enters in and interrupts one IR section that output goes to the controller, then controller drives the ULN driver and ULN driver the stepper motor and closes the gate with buzzer indication. And then when train interrupts another IR section and crosses the that IR section that output goes to the controller ,then controller drives the motor and opens the gate with buzzer indication. In this way railway gate can be controlled involuntarily.

Plot No:#304, D V Arcade, Opp. Agrawala Sweets, Street No: 10, Himayatnagar, Hyderabad - 500 029. www.sahasratechnology.weebly.com

BLOCK DIAGRAM
Power supply

Buzzer ARM 7

Enter IR Sensor

Exit IR Sensor

Stepper Motor

ULN Driver

HARDWARE REQUIREMENTS:

1. ARM7CONTROLLER 2. BUZZER 3. IR SENSORS 4. ULN 2003 5. STEPPER MOTOR 6. POWER SUPPLY

SOFTWARE: 1. KEIL SOFTWARE 2. EMBEDDED C 3. FLASH-MAGIC

Plot No:#304, D V Arcade, Opp. Agrawala Sweets, Street No: 10, Himayatnagar, Hyderabad - 500 029. www.sahasratechnology.weebly.com

You might also like