Q1 Which of the following are the address ranges of .( the private IP addresses?

(Choose three

to 10.255.255.255 10.0.0.0 to 200.100.25.255 200.100.50.0 to 150.150.255.255 150.150.0.0 to 172.31.255.255 172.16.0.0 to 192.168.255.255 192.168.0.0 to 127.31.255.255 127.16.0.0

Q2

Which two functions of the OSI model occur at layer .( two? (Choose two physical addressing encoding routing cabling media access control

Q3 Refer to the exhibit. What function does router RT_A need to provide to allow Internet access for ? hosts in this network address translation DHCP services ftpd web server

Q4

What is true regarding network layer addressing? .( (Choose three uses a flat structure prevent broadcasts heirarchical uniquely identifies each host bits in length 48 contains a network portion

Q5 Refer to the exhibit. Host A attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured with the source MAC address 0050.7320.D632 and the destination MAC address 0030.8517.44C4. The packet inside the captured frame has an IP source address 192.168.7.5, and the destination IP address is 192.168.219.24. At which point in the ? network was this packet captured leaving host A leaving ATL leaving Dallas leaving NYC

Q6 Refer to the exhibit. Assume all devices are using default configurations. How many subnets are required to address the topology that is ? shown 1 3 4 5 7

Q7 A technician is asked to secure the privileged EXEC mode of a switch by requiring a password. Which type of password would require this login ? and be considered the most secure

console enable enable secret VTY

Q8 Refer to the exhibit. A technician is working on a network problem that requires verification of the router LAN interface. What address should be pinged from this host to confirm that ? the router interface is operational 127.0.0.1 192.168.64.196 192.168.254.1 192.168.254.9 192.168.254.254

Q9

Which OSI layer does IP rely on to determine whether packets have been lost and to request ? retransmission

application presentation session transport

Q10 When connectionless protocols are implemented at the lower layers of the OSI model, what is usually used to acknowledge that the data was received and to request the retransmission of ? missing data IP UDP Ethernet a connectionless acknowledgement an upper-layer, connection-oriented protocol or service

Q11 Refer to the exhibit. Host C is able to ping 127.0.0.1 successfully, but is unable to communicate with hosts A and B in ? the organization. What is the likely cause of the problem . Hosts A and B are not on the same subnet as host C . The IP addresses on the router serial interfaces are wrong . The subnet mask on host C is improperly configured The FastEthernet interface fa0/0 of router 1 is wrongly . configured

Q12 Refer to the exhibit. Which list refers only to ? end devices D,E,F,G A,H,B,C A,D,E,F A,D,E,G

Q13 Refer to the exhibit. Host A sends a frame with the destination MAC address as FFFF.FFFF.FFFF. What action will the switch ? take for this frame . It will drop the frame . It will send the frame back to host A . It will send the frame to all hosts except host A It will forward the frame to the default gateway

Q14 Which subnet mask will allow 2040 hosts per ? subnet on the IP network 10.0.0.0 255.255.0.0 255.255.254.0 255.255.252.0 255.255.248.0 255.255.240.0 255.255.255.128

Q15 Refer to the exhibit. RouterB is configured properly. The Ethernet interface Fa0/0 of RouterA is configured with the use of the commands that are shown. However, a ping from the Fa0/0 interface of RouterA to the Fa0/0 interface of RouterB is unsuccessful. What action should be taken on RouterA to solve ? this problem Use the description command on the FastEthernet interface . Fa0/0 . Configure the clock rate of the FastEthernet interface Fa0/0 Use the no shutdown command on the FastEthernet interface . Fa0/0 . Reboot the router

Q16 To send data through a network, what two flags .( are used to establish a session? (Choose two ACK CRC SYN # Ack # Port # Seq

Q17 Which statement is true about the TTL value of an ? IPv4 packet . It determines the priority of a packet . It specifies the remaining "life" of the packet It indicates that the packet has been . fragmented It denotes the data payload type that the packet . is carrying

Q18 Refer to the exhibit. Communication for hosts X and Y is restricted ? to the local network. What is the reason for this . Host X is assigned a network address . Host Y is assigned a multicast address . Host X and host Y belong to different networks . The gateway addresses are broadcast addresses

Q19 What type of network is maintained if a server ? takes no dedicated role in the network

mainframe client/server peer-to-peer centralized

Q20 A routing issue has occurred in your internetwork. Which of the following type of devices should be ? examined to isolate this error access point host hub router switch

Q21 Which physical component is used to access and perform the ? initial configuration on a new unconfigured router

Q22 A user sees the command prompt: Router(config? if)# . What task can be performed at this mode . Reload the device . Perform basic tests . Configure individual interfaces .Configure individual terminal lines

Q23 ? What is the correct order for PDU encapsulation

Q24

What information can be gathered by using the ? command netstat the default gateway the routing protocol active TCP connections the locally configured subnet mask

Q25

How can ARP be used to help document ? the network

. It can list each hop on the way to a destination host . It can show the average latency of hosts on the network .It can provide a list of physical addresses on the network It can indicate which hosts are not responding to network . traffic

Q26

What is the protocol data unit that is associated with the data link layer of ? the OSI reference model
data frame packet segment

Q27 Which application layer protocol allows administrators to log into a server from remote locations and control a server as though logged ? in locally DNS FTP DHCP SMTP Telnet

Q28

Which statement identifies the DNS ? protocol

. It transmits information using TCP port 25 It transfers and conveys information using HTML . pages It matches a resource name with the required . network address It requests and assigns an IP address, default . gateway, and serveraddresses to hosts

Q29 What is the consequence of issuing the erase startup-config command in ? privileged EXEC mode on a Cisco router
. Data stored in RAM will be removed . Data stored in NVRAM will be erased . Information in flash memory will be removed . Flags in the configuration register will be set to 0 Both the startup-config and the running-config . will be erased

Q30 Which password would allow a user to establish a Telnet session with a Cisco ? device
VTY password enable password console password enable secret password

Q31

Which identifier is contained in the header ? of the Layer 2 Ethernet frame

timing and synchronization of bits source and destination port numbers logical source and destination addresses physical source and destination addresses

Q32 What happens when a node on an Ethernet network is creating a frame and it does not have the destination MAC ? address
. The node drops the frame . The node sends out a Layer 3 broadcast message The node sends a message directly to the router for the . address The node sends out an ARP request with the destination . IP address

Q33 An administrator makes changes to the default configuration of a router and saves them to NVRAM. After testing, it is discovered that the configurations did not have the desired effect and must be removed. What steps must be taken to remove the changes and return the router ? to the default configuration
. Reboot the router . Use no version of the commands that are issued Issue the erase startup-config command, and then reboot the . router Issue the erase running-config command, and then reboot the . router

Q34 A network administrator is tasked with connecting two workgroups that are configured to use different subnets. Which device should be selected to allow connectivity between users on the two ? networks
hub switch router wireless access point

Q35 Which two programs can be used to accomplish terminal emulation for configuring a router from the CLI through .( the console port? (Choose two
HyperTerminal Internet Explorer Minicom Secure Shell Telnet

Q36 Which statement accurately describes ? file sharing in a peer-to-peer network

. A dedicated server is required . Access control is decentralized Files are typically stored on the most powerful . peer in the network Peers can either make requests, or respond to . requests, but not both

Q37 What are two primary responsibilities of .( the Ethernet MAC sublayer? (Choose two
frame delimiting data encapsulation logical addressing error detection accessing the media

Q38 Which router configuration mode would an administrator use to configure the router ? for SSH or Telnet login access
line router global interface privileged EXEC

Q39 Refer to the exhibit. Which device should be included in the network topology to provide Layer 2 connectivity for all LAN devices, provide multiple collision domains, and also provide a ? connection to the rest of the network server hub switch PC

Q40 Refer to the exhibit. A technician has been asked to test connectivity from PC1 to a remote network. Which action will ? indicate if there is remote connectivity

Q41

What purpose does a hostname ? serve on a router

uniquely identifies a router on the internet used by routing protocols to identify peer routers provides device identification to users logging on remotely determines the hosts that are allowed to connect to the device

Q42

Which prompt is associated with the ? privileged exec mode

< R1 R1# (# R1(config (# R1(config-router

Q43 A technician wishes to connect two computers to move data from one to the other before reloading the operating system. The NICs on both PCs do not support autosensing feature. Which ? procedure will satisfy the requirement
. Interconnect the two PCs with a rollover cable Interconnect the two PCs with two rollover . cables and a hub . Interconnect the two PCs with a crossover cable Interconnest the two PCs with two crossover . cables and a hub

Q44 Refer to the exhibit. Interface Fa0/0 on router A is generating excessive broadcast traffic. Which LAN segments will affected by the excessive ? broadcasts
. Only the 192.168.1.200/30 network will be affected Only the link between 192.168.1.201 and port Fa0/5 on SW1 will . be affected Both the 192.168.1.200/30 and 192.168.1.204/30 networks will . be affected Only the links between 192.168.1.201 and port Fa0/7 on SW2 . will be affected

Q45 Two routers are connected via their serial ports in a lab environment. The routers are configured with valid IP addresses, but they cannot ping each other. The show interface serial0/0 command shows that the serial0/0 interface is up but the line protocol is down. What could be the cause of ? this problem
The no shutdown command has not been applied to the . interfaces The clock rate command has not been entered on the DCE . interface . The interface timers are not cleared The FastEthernet interface is emulating a serial interface by . assigning it a timing signal

Q46 Refer to the exhibit. Which layered network ? model is shown in the diagram
Cisco IETF OSI TCP/IP

Q47 Refer to the exhibit. Host A is unable to reach host B on the remote network. A technician attempted to ping the local gateway and the ping was successful. To verify the host configuration, the technician issued the ipconfig ? command. What is the likely cause of the problem
. The local NIC is incorrectly configured . The subnet mask on host A is incorrectly configured . The IP address on host A is incorrectly configured

Q48

Which option shows how a router will route ? packets to a remote network

Q49 An organization has been assigned network ID 10.10.128.0 and subnet mask 255.255.224.0. Which IP address range can ? be used for this organization
to 10.10.160.255 10.10.128.0 to 10.10.159.255 10.10.128.0 to 10.10.192.255 10.10.128.0 to 10.10.0.159 10.10.128.0 to 10.10.159.0 10.10.128.0

Q50 A network administrator is configuring several switches for a network. The switches have similar configurations and only minor differences. The administrator wants to save all commands that are issued on the first switch to a text file for editing. Which transfer ? option should be selected in HyperTerminal

:Done by
MiMi RoSe