Scribd
Upload
184 views1 page

Nat Practice Lab

The network associate needs to configure NAT on a router to provide internet access for 14 hosts in the Weaver company's LAN using the 6 public IP addresses provided by their ISP. The router interfaces and static routes have already been configured. The task is to complete the NAT configuration using the IP addresses from the ISP to allow the private hosts to access the internet through the router.

Uploaded by

aennek
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
184 views1 page

Nat Practice Lab

The network associate needs to configure NAT on a router to provide internet access for 14 hosts in the Weaver company's LAN using the 6 public IP addresses provided by their ISP. The router interfaces and static routes have already been configured. The task is to complete the NAT configuration using the IP addresses from the ISP to allow the private hosts to access the internet through the router.

Uploaded by

aennek
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

NAT PRACTICE LAB

Scenario A network associate is configuring a router for the weaver company to provide internet access. The ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110. The company has 14 hosts that need to access the internet simultaneously. The hosts in the company LAN have been assigned private space addresses in the range of 192.168.100.17 192.168.100.30.

The following have already been configured on the router The basic router configuration The appropriate interfaces have been configured for NAT inside and NAT outside The appropriate static routes have also been configured (since the company will be a stub network, no routing protocol will be required.) All passwords have been temporarily set to "cisco"

The task is to complete the NAT configuration using all IP addresses assigned by the ISP to provide Internet access for the hosts in the Weaver LAN. Functionality can be tested by clicking on the host provided for testing.

You might also like