Transponder

In telecommunication, a transponder is one of two types of devices. In air navigation or radio frequency identification, a flight transponder is a device that emits an identifying signal in response to an interrogating received signal. In a communications satellite, a transponder gathers signals over a range of uplink frequencies and re-transmits them on a different set of downlink frequencies to receivers on Earth, often without changing the content of the received signal or signals.

The term is a portmanteau for transmitter-responder. It is variously abbreviated as XPDR, XPNDR, TPDR or TP.

Satellite/broadcast communications

A communications satellite’s channels are called transponders, because each is a separate transceiver or repeater. With digital video data compression and multiplexing, several video and audio channels may travel through a single transponder on a single wideband carrier. Original analog video only has one channel per transponder, with subcarriers for audio and automatic transmission identification service (ATIS). Non-multiplexed radio stations can also travel in single channel per carrier (SCPC) mode, with multiple carriers (analog or digital) per transponder. This allows each station to transmit directly to the satellite, rather than paying for a whole transponder, or using landlines to send it to an earth station for multiplexing with other stations.

Transponder (aeronautics)

A transponder (short-for transmitter-responder and sometimes abbreviated to XPDR, XPNDR, TPDR or TP) is an electronic device that produces a response when it receives a radio-frequency interrogation. Aircraft have transponders to assist in identifying them on air traffic control radar; and collision avoidance systems have been developed to use transponder transmissions as a means of detecting aircraft at risk of colliding with each other.

Air traffic control units use the term "squawk" when they are assigning an aircraft a transponder code, e.g., "Squawk 7421". Squawk thus can be said to mean "select transponder code" or "squawking" to mean "I have selected transponder code xxxx".

Secondary surveillance radar

Secondary surveillance radar (SSR) is referred to as "secondary", to distinguish it from the "primary radar" that works by passively reflecting a radio signal off the skin of the aircraft. Primary radar determines range and bearing to a target with reasonably high fidelity, but it cannot determine target elevation (altitude) reliably except at close range. SSR uses an active transponder (beacon) to transmit a response to an interrogation by a secondary radar. This response most often includes the aircraft's pressure altitude and a 4-digit octal identifier.

Transponder (satellite communications)

A communications satellite's transponder is the series of interconnected units that form a communications channel between the receiving and the transmitting antennas. It is mainly used in satellite communication to transfer the received signals.

A transponder is typically composed of:

Most communication satellites are radio relay stations in orbit, and carry dozens of transponders, each with a bandwidth of tens of megahertz. Most transponders operate on a bent pipe principle, sending back to earth of what goes into the conduit with only amplification and a shift from uplink to downlink frequency. However, some modern satellites use on-board processing, where the signal is demodulated, decoded, re-encoded and modulated aboard the satellite. This type, called a "regenerative" transponder, has many advantages, but is much more complex.