Saturn C-4

The Saturn C-4 was the fourth rocket in the Saturn C series studied from 1959 to 1962. The C-4 design was proposed in 1960 for a three-stage launch vehicle that could launch 99,000 kg (218,000 lb) to Low Earth orbit and send 32,000 kg (70,000 lb) to the Moon via Trans-lunar injection. It met the initial requirements for a lunar orbit rendezvous and lunar landing mission.

It would have consisted of three stages; an S-IB-4 first stage, a S-II-4 second stage and a S-IVB third stage. The first and second stages were essentially four-engine variants of the stages that would be used on the Saturn V, while the IVB stage was actually used on both the Saturn V and the Saturn IB.

It would have been capable of sending the 30,000 kg (67,000 lb) Apollo Command/Service Module into lunar orbit, but it would not have been able to carry the 15,000 kg (32,000 lb) Apollo Lunar Module as well. Although NASA eventually used the lunar orbit rendezvous method to go to the Moon, it decided to use the larger Saturn V which would provide a reserve payload capacity.

C4

C4, C04, C.IV, C-4, or C-04 may refer to:

People

Biology

Vehicles

Aircraft

C-4 (explosive)

C-4 or Composition C-4 is a common variety of the plastic explosive family known as Composition C. The British version of the explosive is known as PE-4 (Plastic Explosive). C-4 is composed of explosives, plastic binder, plasticizer to make it malleable, and usually a marker or odorizing taggant chemical.

C-4 has a texture similar to modeling clay and can be molded into any desired shape. C-4 is stable and an explosion can only be initiated by the combination of extreme heat and shock wave from a detonator.

Characteristics and uses

Composition

The Composition C-4 used by the United States Armed Forces contains 91% RDX ("Research Department Explosive", an explosive nitroamine), 5.3% dioctyl sebacate (DOS) or dioctyl adipate (DOA) as the plasticizer (to increase the plasticity of the explosive), 2.1% polyisobutylene (PIB, a synthetic rubber) as the binder, and 1.6% of a mineral oil often called "process oil". Instead of "process oil", low-viscosity motor oil is used in the manufacture of C-4 for civilian use.