Millipede memory
Millipede memory is a non-volatile computer memory stored on nanoscopic pits burned into the surface of a thin polymer layer, read and written by a MEMS-based probe. It promised a data density of more than 1 terabit per square inch (1 gigabit per square millimeter), which is about the limit of the perpendicular recording hard drives. Millipede storage technology was pursued as a potential replacement for magnetic recording in hard drives, at the same time reducing the form-factor to that of flash media. IBM demonstrated a prototype millipede storage device at CeBIT 2005, and was trying to make the technology commercially available by the end of 2007. However, because of concurrent advances in competing storage technologies, no commercial product has been made available since then.
Technology
Basic concept
The main memory of modern computers is constructed from one of a number of DRAM-related devices. DRAM basically consists of a series of capacitors, which store data as the presence or absence of electrical charge. Each capacitor and its associated control circuitry, referred to as a cell, holds one bit, and bits can be read or written in large blocks at the same time. In contrast, hard drives store data on a disk that is covered with a magnetic material; data is represented as local magnetisation of this material. Reading and writing are accomplished by a single head, which waits for the requested memory location to pass under the head while the disk spins. As a result, the drive's performance is limited by the mechanical speed of the motor, and is generally hundreds of thousands of times slower than DRAM. However, since the "cells" in a hard drive are much smaller, the storage density is much higher than DRAM.