Inverse filter

In signal processing, for a filter g, an inverse filter h is one such that the sequence of applying g then h to a signal results in the original signal. Software or electronic inverse filters are often used to compensate for the effect of unwanted environmental filtering of signals.

In speech science

In all proposed models for the production of human speech, an important variable is the waveform of the airflow, or volume velocity, at the glottis. The glottal volume velocity waveform provides the link between movements of the vocal folds and the acoustical results of such movements, in that the glottis acts approximately as a source of volume velocity. That is, the impedance of the glottis is usually much higher than that of the vocal tract, and so glottal airflow is controlled mostly (but not entirely) by glottal area and subglottal pressure, and not by vocal-tract acoustics. This view of voiced speech production is often referred to as the source-filter model.

A technique for obtaining an estimate of the glottal volume velocity waveform during voiced speech is the “inverse-filtering” of either the radiated acoustic waveform, as measured by a microphone having a good low frequency response, or the volume velocity at the mouth, as measured by a pneumotachograph at the mouth having a linear response, little speech distortion, and a response time of under approximately 1/2 ms. A pneumotachograph having these properties was first described by Rothenberg and termed by him a circumferentially vented mask or CV mask.

Inverse filter (disambiguation)

Inverse Filter may refer to:

In Human Speech:

In Control Theory and Signal Processing: