Summary of Cylon Pumpkin Using Arduino
This project describes creating a Cylon-style LED scanner effect using a Boarduino (Arduino clone) to control 14 LEDs. The LEDs are arranged in a bar and lit sequentially up and down to mimic the Cylon eye movement. Only one current-limiting resistor is used since LEDs are lit one at a time. The LED bar is split and wired with female headers for easy connection to the Boarduino. The provided code cycles through turning each LED on and off with delays for the scanning effect.
Parts used in the Cylon Pumpkin Scanner:
- Boarduino (Arduino clone)
- 14 LEDs
- One current-limiting resistor (approx. 500 ohms or two 1k-ohm resistors in parallel)
- Proto-board (two pieces spliced together)
- 8-pin female headers
- Connecting wires
This has been done before. There are several good ways to do it: most use either a 555 timer chip and decimal counter chip, or an Arduino. Stefan and I used an Arduino (Boarduino, technically) which limited our scanner to 14 LEDs. No problem — 14 gives a nice scanning effect!
Here’s how we wired it: the numbers on the Boarduino block refer to the digital lines d0–d13.
// Cylon pumpkin driver
// Eric Ayars
// 10/24/09
#define MAXLIGHT 14
byte Wait = 50; // Time each light is on, in ms
byte EndWait = 250; // Time all lights are off at the ends
void setup() {
// Set all pins to output
for (byte j=0;j
pinMode(j,OUTPUT);
}
}
void loop() {
// Count up from 0 to 13, setting the light
// for each count.
for (byte j=0;j
digitalWrite(j,HIGH);
delay(Wait);
digitalWrite(j,LOW);
}
// Pause at the end
delay(EndWait);
// Count back down from 13 to 0, setting lights
// as it goes again.
for (int j=MAXLIGHT-1;j>=0;j--) {
digitalWrite(j,HIGH);
delay(Wait);
digitalWrite(j,LOW);
}
// Pause at the end
delay(EndWait);
}Here’s Stefan with the completed “eye-bar”. We didn’t have a section of proto-board long enough to hold the entire scanner, so we split a long piece and spliced it together in the middle with short wires. This gave us the option of bending the unit in the center, which proved handy when mounting it in the pumpkin!
Rather than solder the eye-bar directly to the Boarduino pins, we soldered the wires to 8-pin female headers that then connected to the Boarduino. We labeled the headers to avoid confusion. 🙂 One side of the Boarduino has pins 0-7, and the other side has pins 8-13 and a connection to ground.
For more detail: Cylon Pumpkin Using Arduino
