Summary of about controlling your system with arduino
The user is seeking confirmation about substituting the EasyDriver v3 stepper motor drivers with the Adafruit Motor/Stepper/Servo Shield for Arduino kit v1.0 in a stepper motor control project. They provide a parts list inferred from a schematic found online and inquire if the listed components are compatible with the schematic and associated code, while also requesting updated schematics if available.
Parts used in the Stepper Motor Control Project:
- IRF540 MOSFET (IRF540NPBF)
- LD1117 3.3V Voltage Regulator (LF33CV)
- BS170 Transistor (x2)
- LM317T Voltage Regulator (x2)
- 10K Potentiometer
- 1K Resistor (x2)
- 10K Resistor (x2)
- Arduino Uno R3 (Atmega328)
- EasyDriver v3 Stepper Motor Driver (x2) or Adafruit Motor/Stepper/Servo Shield v1.0 (x2) as replacement
- Stepper Motor - 200 steps/rev, 12V 350mA (x2)
Hi all,
First of all , i’m dutch and from Belgium.
I’m new with and for David-laser. I tried to find a clear site and list for controlling. I’ve found this schematic through ‘google’
I was wondering, can i use Adafruit Motor/Stepper/Servo Shield for Arduino kit – v1.0 instead those easydriver v3
according the image:
left is the partlist from the image and at right is what i think i needed (for ordering)
1x mosfet irf540 IRF540NPBF
1x LD111 7V33 LF33CV
2x bs170 bs170 (same)
2x LM317T LM317T (same)
1x pot 10K pot 10K (same)
2x 1K 1K (same)
2x 10K 10K (same)
1x arduino UNO Arduino Uno R3 (Atmega328 – assembled) –
2x easydriver v3 Adafruit Motor/Stepper/Servo Shield for Arduino kit – v1.0
2 x steppermotor Stepper motor – 200 steps/rev, 12V 350mA
Hopely can some one confirm this list will be compatible with the schematic and code. Or newer schematics link wound be nice.
thx advanced
For more detail: about controlling your system with arduino