wreaths

Christmas Bubble Wreath Tutorial

Christmas Wreath Tutorial

Christmas Ribbon Wreath DIY

Fall Wreath/ How To Make a Turkey Wreath/ Thanksgiving Decor/ Fall Wreath #fallwreath #shorts #fall

How to Make a Wired Ribbon Flower Center - Easy DIY Ribbon Rosette with Carrie's Wreath Creations

6 Tips to Reduce Deco Mesh Fraying

6 WAYS TO MAKE A DECO MESH BASE WREATH - HOW TO MAKE A WREATH COMPILATION 2021 #wreathtutorial

How to make a CURL method base wreath

How to make a CURL method base wreath

3.2M views · 26K reactions | Fall Ribbon Wreath | Fall Ribbon Wreath | By We Craft Around | Hey, everybody. It's Beth. Today, I'll be making a fall ribbon wreath. I'm using four different pattern ribbons. They are two and a half inches wide and they are wired. I cut twenty-four strips of each pattern and I cut them down to 8 inches. So, you'll need six yards total per design. Once I had those strips cut, I go ahead and trim up the ends. I then went ahead and cut all of my pieces of twine ahead of time. What I'm doing is making little ribbon bundles. I take the first ribbon and I pinch it in the center and then hold that pinch in my hand and then do the same to the other three and crisscross them back and forth in my hands kind of in a shape of an X until I have all four ribbons total then take that twine piece I had cut wrap it around the center knot it a couple times and then leave that twine long because that's how I'll be attaching it to the wreath form. And for the next two I'm just alternating the ribbons so they're not exactly the same for each bundle. I use three different variations of the ribbons in different orders each time. So you'll wind up with twenty-four bundles total. Next I'm taking my 18 inch wreath form that I got from Dollar Tree and I am taking the bundles and I wrap it around that center ring knotting it a couple times and then cutting off the excess twine. Each of those sections will have three bundles. So in each section I have one of each variation of the different patterns of the ribbons. The different orders of the patterns. And then I just spread the ribbons out and fluff them out. So each section will be nice and filled in. I just continue that until I have it completely filled in. And then I'm taking this welcome hanger that I got from Dollar Tree and I remove the hanger from the back and I paint the entire thing with the color camel and that's by faux cart. It's an acrylic paint and I just give this full coverage After I have it painted and dried, I cut a couple pieces of twine and on either end, I attach it by using a stapler. I place it down on top of the wreath where I am going to want it and just take that twine and push it through the ribbons and tie it on the back like I had attached each of those ribbon bundles. Once that's attached, I just go around and open up all the ribbon bundles and just making sure that the wreath is nice and full. That is it for this project. Thank you so much for watching.

DIY Sun Catcher from old CDs 💿

Sunflower Bandana Wreath