Roof Flashing

Roofing contractor Dyami Plotke explains the best way to install rake and eave flashing.

Counter flashing is the final layer of a three-part waterproof barrier installed between a roof and a vertical wall or chimney. The first two layers are called base flashing and step flashing. The term reglet flashing refers to an installation method for counter flashing, not a separate layer.

A roof drip edge directs water into the gutters. Discover the proper drip edge for a roof and how to install it, including how to cut it for corners.

Leak-proof your chimney using this traditional, time-tested flashing method.

#FaheyFriday •Flashing such as transitions in metal roofing are critical to be done correctly. Overlapping and improper flash specs can cause massive damage damage when snow and ice begin to melt and back up. Be sure that a channel and or closure is installed. •#Fahey ##metal

Guide describing how to install step and kick-out flashing on roofs.

How to install step flashing, properly connect roof to siding, with proper kick out, by Kansas City company, Larry L. Vaught Roofing, Inc.

This dormer window, built by Principle Constructions (Instagram: @principle_constructions) has used Cladco 32/1000 Box Profile Roof Sheets alongside Corner Flashings for a well-protected, seamless finish. Roof Flashings are used to seal the ends and corners of a run of Sheets, helping to protect your building against water intrusion. As well as being an integral component of your box profile roof, Flashings are a good way to enhance the aesthetics of your project. Find out more online.