|
Author(s)
|
García-Matos, Jesús A (Madrid, CIEMAT ; Madrid, Polytechnic U.) ; Calero, Jesús (Madrid, CIEMAT) ; Domínguez, Manuel Ángel (Madrid, CIEMAT) ; Fernández, Alejandro (Madrid, CIEMAT) ; Gómez, Pablo (Madrid, CIEMAT) ; García-Tabarés, Luis (Madrid, CIEMAT) ; López, Daniel (Madrid, CIEMAT) ; Martínez, Luis Miguel (Madrid, CIEMAT) ; Martínez, Teresa (Madrid, CIEMAT) ; Munilla, Javier (Madrid, CIEMAT) ; Pardo, Jose A (Madrid, CIEMAT) ; Pérez, Jose M (Madrid, CIEMAT) ; Sobrino, Pablo (Madrid, CIEMAT) ; Toral, Fernando (Madrid, CIEMAT) ; Bajko, Marta (CERN) ; Emami, Sohrab (CERN) ; Fiscarelli, Lucio (CERN) ; Guinchard, Michael (CERN) ; Bermúdez, Susana Izquierdo (CERN) ; Mangiarotti, Franco J (CERN) ; Perez, Juan C (CERN) ; Todesco, Ezio (CERN) ; Willering, Gerard (CERN) |
|
Abstract
| The first prototype of the short orbit corrector for the upgrade of the LHC has been fabricated at CIEMAT, in collaboration with CERN, in the framework of the HL-LHC project. It consists of two nested dipoles, with an aperture of 150 mm and physical length of 1.5 m. A first power test was performed without the outer dipole coils, which were replaced by a support structure to align the iron yoke with the collared inner dipole. This test was aimed to validate the coil fabrication techniques, which are innovative for a NbTi Rutherford cable. In the power test of the full assembled magnet, individual training of both dipoles was fine to ultimate current. However, the magnet was not able to reach nominal torque in combined operation. Several power tests and re-assemblies were necessary to be able to power both dipoles till nominal current. This paper describes the test results and analysis of the measurements. The magnet is heavily instrumented with voltage taps, collars with strain gauges and bullet gauges at the axial pushers. |