| Article | |
| Title | Investigating the effect of rolling deformation on the electro-mechanical limits of Nb$_{3}$Sn wires produced by RRP$^{®}$ and PIT technologies |
| Author(s) | Bagni, T (U. Geneva (main) ; Uppsala U.) ; Calzolaio, C (PSI, Villigen) ; Bovone, G (U. Geneva (main)) ; Ferradas-Troitino, J (CERN) ; Barth, C (CERN) ; Ballarino, A (CERN) ; Senatore, C (U. Geneva (main)) |
| Publication | 2024 |
| Number of pages | 16 |
| In: | Supercond. Sci. Technol. 37 (2024) 095013 |
| DOI | 10.1088/1361-6668/ad6a9c |
| Subject category | Accelerators and Storage Rings |
| Abstract | Future high-field magnets for particle accelerators hinge on the crucial development of advanced Nb$_{3}$Sn wires engineered to withstand the large stresses generated during magnet assembly and operation. The superconducting properties of Nb$_{3}$Sn enable the design of compact accelerator-quality magnets above 10 T, but at the same time the brittleness and strain sensitivity of the material impose careful consideration of the mechanical limits. In addition, accelerator magnets are wound using Rutherford cables and the cabling process generates deformations in the wire that can affect its electro-mechanical performance. This paper reports on the impact of the rolling deformation on the transverse stress tolerance of high-performance restacked-rod-process (RRP$^{®}$) and powder-in-tube (PIT) Nb$_{3}$Sn wires. Rolling deformation was used to mimic the effect of cabling on the wire shape. Deformed samples were compared to reference round wires in term of stress dependence and irreversible limit (σ$_{irr}$) of the critical current (I$_{c}$) under transverse compressive loads up to 240 MPa. Experiments were performed at 4.2 K, 19 T, on resin-impregnated single wires that imitate the operating conditions in a Rutherford cable of an accelerator magnet. The results show that rolling deformation has a detrimental effect on the initial I$_{c}$ of PIT wires, but it does not influence the behavior of the wire under stresses above 70 MPa. On the other hand, the deformation of RRP$^{®}$ wires leads to an improved σ$_{irr}$ without affecting the initial I$_{c}$. Additionally, a 2D-mechanical finite element method model of the RRP$^{®}$ wire was developed to investigate the impact of the wire geometry on the plastic deformation of the copper matrix, which induces residual stresses on Nb$_{3}$Sn and is the main cause for the permanent reduction of I$_{c}$. Based on the model results, an alternative layout of the wire was proposed that improves its stress tolerance without affecting its electrical transport properties. |
| Copyright/License | © 2024-2025 The Author(s) (License: CC-BY-4.0) |
Corresponding record in: Inspire
Datensatz erzeugt am 2024-08-22, letzte Änderung am 2024-08-22
