CERN Accélérateur de science

ATLAS Slides
Report number	ATL-TILECAL-SLIDE-2021-623
Title	Control System of Upgraded High Voltage for Atlas Tile Calorimeter
Author(s)	Martins, Filipe (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT)) ; Mendes De Oliveira Cuim, Filipe (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT)) ; Gaspar De Andrade Evans, Guiomar (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT)) ; Da Silva Gurriana, Luis Miguel (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT)) ; Da Silva Gomes, Agostinho (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT)) ; Soares Augusto, Jose Antonio (LIP Laboratorio de Instrumentacao e Fisica Experimental de Particulas (PT))
Corporate author(s)	The ATLAS collaboration
Collaboration	ATLAS Collaboration
Submitted to	18th International Conference on Accelerator and Large Experimental Physics Control Systems, Online, 18 - 22 Oct 2021
Submitted by	[email protected] on 25 Oct 2021
Subject category	Particle Physics - Experiment
Accelerator/Facility, Experiment	CERN LHC ; ATLAS
Free keywords	ATLAS ; TileCal ; DCS ; High Voltage
Abstract	The preparation of the upgrade of the ATLAS electronics for the High Luminosity LHC is in full swing. The Tile Calorimeter is preparing the upgrade of its readout electronics and power distribution systems. One of such systems is the high voltage (HV) regulation and distribution system. The new system is based on HVRemote boards mounted in crates located at the counting room. The HV will be delivered to the on-detector electronics using 100 m long cables. The crates will be equipped with a system-on-chip (SoC) that will be responsible for the control and monitoring of the HV boards. The control of the HVRemote and its dedicated HVSupply boards is done by means of a serial peripheral interface (SPI) bus. A SCADA component is under development to communicate with and supervise the crates and boards, and to integrate the HV system in the control system of the detector. The control system will be able to send notifications to the operators when the monitored values are out of range, archive the monitored data and if required, perform automated actions.